Airbag DTCs don't match chart.

[gt_2ner]

OK trying to figure out my airbag codes on a 2005 G35coupe. I am able to get the DTCs to flash but they don't match any of the signals I have seen on the chart.

I get a 3 seconds on,two seconds off,two quick flashes,2 seconds off,2 more quick flashes, then 2 seconds off, then back to the 3 second on and repeat.

Car was hit on front and right. All airbags replaced,seatbelts replaced with new, module sent out for reset. sensor in door not replaced but I read it should reset itself.

I guess the next course of action is to get the OBDII signals read but the inexpensive readers don't show any codes. Probably need to hit someone up that has a snap-on style reader instead of the autozone style readers?

any ideas? Thanks In Advance.

[gt_2ner]

Well I found the wiring to the driver airbag fried. But I still dont know why the code doesnt match?

[CPV35]

Your orange connector is missing. Is that how you found it, connector missing and wires snipped?

Whoever fixed your G from accident and replaced bags should be liable from botched replacement install imo.

G/L

[gt_2ner]

Yes that is the way I found it. I ordered new a new clock spring hope this solves the issue.

[CPV35]

Wow...scary thought knowing installer did that. Hopefully new clockspring solves your issue.

I'd personally be concerned with the other components replaced with their correct connections, or more so lack of after seeing that 'fail'...

[gt_2ner]

Okay I finally installed the new clockspring problem cleared no more SRS problem. Thread closed! thx