|
|
|
#1
|
||||
|
||||
|
hey guys been gettin ramdon slip vdo ligths went strartin my g35 and loose all my throltle any sugestions?
|
|
#2
|
||||
|
||||
|
There is a problem with your electric throttle control actuator. Here is a good thread with information for your code and condition.
http://x.infinitihelp.com/forum/show...ighlight=P1121
__________________
FX35 AWD, Touring, Stillen STB, +2 Timing, Stillen CAI, LMS Z-Tube, Escutcheon, Sport Pedals, LED Dtrl's, Motordyne Plenum Spacer is next - when I get to it ![]() Visit my profile and don't forget you can customize yours and set up your own photo album right in your profile |
|
#3
|
||||
|
||||
|
i dont understand what you wrote, but we need more info describe the recent service or aftermarket parts you have done, when was the last time the car was serviced? what are the symptoms? how many miles? a quick glance at the service manual you canget some info. all the info is located in the above tabs, knowledgebase is where its at
__________________
2002 Maxima GLE Silver on Black | Berk Intake w/AEM Dryflow | Clear Sidemarker Lights w/PIAA |Fibre Customs EyeLids | PIAA White Fogs | 5% Limo Tint | Brembo Blanks and Hawk HPS Pads| EBAY FSTB|CATTMAN RSB | NWP VIAS block Plate | OEM Spoiler |07 350z rims wrapped in 235/45/18 Goodyear Eagle GT| in trainingSHOW YOUR SUPPORT : Subscribe |
|
#4
|
||||
|
||||
|
when I came back from vacations whent to supermarket car stated fine but throttle was not workin, had the slip ligth on turn it of and then was fine it has happen afew time after a short drive.
sat did a throttle body clean up, my engine lith still on no more problems so far but idlle is a bit to high did change my air filter 2. ps never got the boddy out just started the car and spayed Thanks Mariano |
|
#5
|
||||
|
||||
|
oooo i dont think thats a good idea.. you might have problems now. try unplugging the battery and performing a idle relearn. you need to take it and carefully clean it, it may be too late but try reset and idle relearn.
__________________
2002 Maxima GLE Silver on Black | Berk Intake w/AEM Dryflow | Clear Sidemarker Lights w/PIAA |Fibre Customs EyeLids | PIAA White Fogs | 5% Limo Tint | Brembo Blanks and Hawk HPS Pads| EBAY FSTB|CATTMAN RSB | NWP VIAS block Plate | OEM Spoiler |07 350z rims wrapped in 235/45/18 Goodyear Eagle GT| in trainingSHOW YOUR SUPPORT : Subscribe |
|
#6
|
||||
|
||||
|
we had a video in the DIY section of the main page towards the bottom http://x.infinitihelp.com/forum/show...lter-3203.html you should have looked around and watched this video before attempting doing it yoursself. he does list the reset procedure towards the end of video. good luck man keep us posted
__________________
2002 Maxima GLE Silver on Black | Berk Intake w/AEM Dryflow | Clear Sidemarker Lights w/PIAA |Fibre Customs EyeLids | PIAA White Fogs | 5% Limo Tint | Brembo Blanks and Hawk HPS Pads| EBAY FSTB|CATTMAN RSB | NWP VIAS block Plate | OEM Spoiler |07 350z rims wrapped in 235/45/18 Goodyear Eagle GT| in trainingSHOW YOUR SUPPORT : Subscribe |
|
#7
|
||||
|
||||
|
ok will unplug batt for 10 min and then do the procedure,hope that works as far as my slip problem is gone, yes i did looked at the video wile perfoming the clean, just did felt comfortable to take the boddy out, will you recomend to take it out and start all over, can do that Saturday?
Thank Mariano |
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|