-REVISED- VARIOUS INFINITI MODELS; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING
The MIL is ON in an APPLIED VEHICLE with DTC P0456 (EVAP VERY SML LEAK) AND
DTC P0456 is not caused by a loose fuel fill cap (refer to ITB13-044).
An EVAP leak has been detected where the vent control valve mounts to the canister.
The vent control valve O-ring seal is determined to be the cause.
VARIOUS INFINITI MODLES; INFINITI; FUEL TANK IS SLOW OR DIFFICULT TO FILL
The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full).
VARIOUS INFINITI MODELS; BALL JOINT AXIAL END PLAY PROCEDURE
When working on the front suspension, use the updated service information in this bulletin along with the Electronic Service Manual (ESM).
VARIOUS INFINITI MODELS; DIAGNOSIS INFORMATION FOR ABS DTC C1130
When diagnosing for DTC C1130 (ENGINE SIGNAL): ECM related DTCs (P-codes) must be diagnosed, repaired, and DTCs erased first.
VARIOUS INFINITI MODELS; FRONT SONAR PARKING SENSOR SERVICE INFORMATION
When diagnosing the front sonar parking sensor for potentially unwanted activation (e.g. sonar activates with no obstacle ahead), inspect the front license plate, front license plate frame and if equipped, the front license plate bracket.
VARIOUS INFINITI MODELS; INFINITI INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES
The Intelligent Keys used on the various Infiniti vehicles may not be interchangeable between models and years.
ALL INFINITI MODELS; SERVICING RUN FLAT TIRES AND LOW PROFILE TIRES EQUIPPED WITH TPMS SENSORS
When servicing run flat tires or low profile tires:
Special equipment and procedures are required to avoid damage.
Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires.
TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty.
To avoid such damage, ensure that the tire changer being used and the operator of the tire changer are capable of servicing run flat and low profile tires.
Operator’s manuals for such tire changers must be followed.
2005-2015 ALL INFINITI MODELS; ECM REPROGRAMMING SERVICE INFORMATION
After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming.
VARIOUS INFINITI MODELS; PRECAUTIONS FOR CLEANING PAINTED ALLOY WHEELS
The appearance of painted alloy wheels can be damaged if acidic cleaners are used