VARIOUS INFINITI MODELS; FRONT SONAR PARKING SENSOR SERVICE INFORMATION
When diagnosing the front sonar parking sensor for potentially unwanted activation (e.g. sonar activates with no obstacle ahead), inspect the front license plate, front license plate frame and if equipped, the front license plate bracket.
VARIOUS INFINITI MODELS; INFINITI INTELLIGENT KEY REPLACEMENT OR SWAPPING BETWEEN VEHICLES
The Intelligent Keys used on the various Infiniti vehicles may not be interchangeable between models and years.
2015-2016 INFINITI QX80; REAR CARPETED FLOOR MAT INSTALLATION
Follow the procedure described in this bulletin to ensure a proper fit over the rear floor tunnel when installing a new carpeted floor mat in an Applied Vehicle.
2015 INFINITI QX80; MIL ON WITH DTC FOR A/F SENSOR
The MIL is ON with one or more of the following DTCs stored: Bank 1
P2096, P2097 – POST CAT FUEL TRIM SYS B1
P0130, P0131, P0132 – A/F SENSOR1 (B1)
P0031, P0032 – A/F SEN1 HTR (B1)
P014C, P014D, P015A, P015B – Air fuel ratio (A/F) sensor 1 (bank 1) Bank 2
P2098, P2099 – POST CAT FUEL TRIM SYS B2
P0150, P0151, P0152 – A/F SENSOR1 (B2)
P0051, P0052 – A/F SEN1 HTR (B2)
P014E, P014F, P015C, P015D – Air fuel ratio (A/F) sensor 1 (bank 2)
2014-2015 INFINITI QX60, QX60 Hybrid, QX80; POWER MOONROOF INITIALIZATION SERVICE INFORMATION
Power moonroof initialization procedures for the Applied Vehicles have been revised.
ALL INFINITI MODELS; SERVICING RUN FLAT TIRES AND LOW PROFILE TIRES EQUIPPED WITH TPMS SENSORS
When servicing run flat tires or low profile tires:
Special equipment and procedures are required to avoid damage.
Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires.
TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty.
To avoid such damage, ensure that the tire changer being used and the operator of the tire changer are capable of servicing run flat and low profile tires.
Operator’s manuals for such tire changers must be followed.
2005-2015 ALL INFINITI MODELS; ECM REPROGRAMMING SERVICE INFORMATION
After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming.
VARIOUS INFINITI MODELS; PRECAUTIONS FOR CLEANING PAINTED ALLOY WHEELS
The appearance of painted alloy wheels can be damaged if acidic cleaners are used