2013 INFINITI JX35, 2014–2017 QX60; RADIATOR SHROUD AND COOLING FAN ASSEMBLY REPLACEMENT PROCEDURE
When replacing the radiator shroud and cooling fan assembly for any reason, the engine coolant, air cleaner case, and air duct does not need to be removed as part of the procedure.
-REVISED- 2014–2016 INFINITI QX60, 2013 JX35; OCCUPANT CLASSIFICATION SYSTEM RETROFIT
The information in this bulletin is provided for customers who have concerns with their Occupant Classification System (OCS) operation after all campaigns have been completed.
-REVISED- VARIOUS INFINITI MODELS; DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING
The MIL is ON in an APPLIED VEHICLE with DTC P0456 (EVAP VERY SML LEAK) AND
DTC P0456 is not caused by a loose fuel fill cap (refer to ITB13-044).
An EVAP leak has been detected where the vent control valve mounts to the canister.
The vent control valve O-ring seal is determined to be the cause.
-REVISED- VARIOUS INFINITI MODELS; OIL LEAKING AROUND TIMING CONTROL SOLENOID VALVE
Engine oil is leaking from a valve timing control solenoid valve.
And
The valve timing control solenoid valve operates correctly and is not externally damaged.
VARIOUS INFINITI MODELS; DTC P0036 DIAGNOSTIC INFORMATION
The Electronic Service Manual (ESM) information for DTC P0036 may be inaccurate or incomplete for the Applied Vehicles.
If an Applied Vehicle stores a DTC P0036, follow diagnostic procedures in the ESM for Bank 2 A/F Sensor Heater open or shorted.
2013-2017 ALL INFINITI MODELS; CLEANING FRONT OR REAR COMBINATION LAMP ASSEMBLIES
When cleaning the “Front Combination Lamp” (Headlight housing) or “Rear Combination Lamp” (Taillight housing) assemblies:
Use only a mild soap (special vehicle soap or general purpose dishwashing liquid), mixed with clean lukewarm (never hot) water.
Use a sponge or soft rag.
DO NOT USE:
Strong household soap, strong chemical detergents, gasoline or solvents.
2016-2017 INFINITI QX60 AND QX60 HYBRID; REVISED WHEEL ALIGNMENT SPECIFICATIONS
For the Applied Vehicles, some wheel alignment specifications listed in the Front Suspension (FSU) and Rear Suspension (RSU) sections of the Electronic Service Manual (ESM) have been revised.
VARIOUS INFINITI MODLES; INFINITI; FUEL TANK IS SLOW OR DIFFICULT TO FILL
The fuel tank is slow or difficult to fill (filling nozzle shuts off before tank is full).