ALL INFINITI MODELS; LOW TIRE PRESSURE WARNING SYSTEM;
This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for:
Basic Diagnosing of TPMS/LTPWS systems.
Aftermarket wheels.
Inflating/deflating tires with TPMS/LTPWS sensors.
Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration.
Radio Frequency interference causing a “No Data” (C1708, C1709, C1710, C1711) condition.
Sensor leaks.
Air pressure changes with altitude and ambient temperatures.
-REVISED- 2011-2013 INFINITI QX56; WHINE NOISE FROM ENGINE AREA
A whine type noise is coming from the Bank 2 (B2) side of the timing chain system.
• The noise is best heard from the high pressure fuel pump area.
• The noise should increase in frequency with engine speed (RPM).
• If the noise does not increase with engine speed, the timing chain system may not be the cause.
Refer to the appropriate section of the Electronic Service Manual (ESM) for further diagnosis.
2013 INFINITI MODELS; AUTO HEADLAMPS ON IN DAYLIGHT WHEN FOG LAMPS TURNED
When the headlamp switch is set to the AUTO position,
AND
the fog lamp switch is turned ON, the fog lamps and headlamps are designed to come on, regardless of ambient lighting.
ALL INFINITI MODELS 2009 AND UP; CRUISE CONTROL WILL NOT SET AND DTC P0605 IS STORED
Improper adjustment or operation of the ASCD brake switch can cause the Automatic Speed Control Device (ASCD) to “not set” and/or DTC P0605 (ECM) to store.
If a malfunction in the ASCD system is detected, the “CRUISE” indicator may stay ON and the “SET” indicator may flash.
ALL INFINITI MODELS; LOCK/UNLOCK REQUEST BUTTON ON OUTSIDE DOOR HANDLE DOES NOT RESPOND
The “Lock / Unlock request buttons” that are located on the outside door handles of vehicles with Intelligent Key can be disabled (or enabled) through either the "Comfort & Conv." settings of the Audio/Visual/Navigation system, or through the “Combination Meter settings” depending on the vehicle model, year and trim level.
ALL INFINITI MODELS; REMOVING FOREIGN MATERIAL FROM THE WINDSHIELD
Windshield “foreign material” that is on the surface of the glass in some cases can be cleaned off with a very particular type and grade of steel wool.
2005-2013 ALL INFINITI MODELS; CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART
This TSB is for troubleshooting of CAN Modules with “Diag-On-CAN” Diagnostics. The flow charts are meant to troubleshoot current CAN DTCs. The flow charts are intended to diagnose one module at a time; repeat the process as needed for additional control units.
1990-2013 ALL INFINITI MODELS; STRUT REPLACEMENT GUIDELINES
This bulletin provides information to identify:
A leaking strut or a shock absorber that qualifies for replacement under warranty.
A strut or shock absorber that has slight oil seepage, a condition which is considered normal, does not affect strut/shock absorber operation or performance, and does not require replacement.
A strut or shock absorber that should be replaced due to rod resistance/noise issues.